装载机离合器使用注意事项

装载机离合器需要定期清洁壳体，检查调整分离间隙、定期注入润滑脂，必要时清洗摩擦片上的油渍，必须正确使用妥善保养。

1、在安装装载机离合器时，应在分离轴承内腔填满钙基润滑脂，本机分离轴承外部设有黄油嘴，应定期限量地注入凡士林(黄油)。分离离合器时，动作要迅速，并彻底分离。
When you install the loader clutch release bearing cavity should fill in the calcium-based grease, this machine has a separate exterior bearing grease fittings should be periodically injected Limited Vaseline (butter). When the clutch, action should be promptly and thoroughly separated.
2、接合离合器时，应缓慢放松踏板，使之柔和平稳地接合。应先用定位心轴插入轴承内，以使主、副摩擦片总成的花键孔与飞轮同心，便于变速器总成的连接安装。
When engaging the clutch pedal should be slow to relax so soft smooth engagement. Should be used to locate mandrel inserted into the bearing, so that the primary and secondary friction plate spline hole assembly concentric with the flywheel for easy connection to install transmission assembly.

3、离合器分离时间不宜过长，一般不超过15-20s。
Clutch time not too long, usually no more than 15-20s.
4、控制车速不要用离合器半分离的办法，以免摩擦片和分离轴承迅速磨损。同时，在行驶时，不要把脚放在离合器踏板上。
Do not control the speed of separation clutch half way in order to avoid friction plate and release bearing rapid wear. Also, when traveling, do not put your foot on the clutch pedal.