济南装载机变速器原位检修的步骤

济南装载机http://www.sdyongbaojixie.com/在施工过程中出现倒档严重无力现象，判断为倒挡活塞油封损坏。根据对济南装载机的操作经验，可以实行原位检修，不仅节省时间，而且安全可靠，那么原位检修有哪些步骤呢？下面永保机械的有关专家就给大家详细介绍一下。

1、先放尽济南装载机变速器内的液压油，然后拆下变速器端盖上的10个固定螺栓，取下端盖；用2个M10的螺栓拧进中间输出齿轮的起吊螺孔内，将直接挡装配体取出；拧下中盖板上8个固定螺栓，取出I挡油缸总成与I挡活塞装配体；取下15个弹簧和弹簧销轴；取下I挡离合器主、从动摩擦片，再取出I挡内齿圈和余下的从动片及主动片；取出I挡行星轮架与倒挡内齿圈装配体。
First exhausted Jinan loader hydraulic oil within the transmission and remove the 10 bolts on the transmission cover, remove the cover; inside with two M10 bolts screwed into the intermediate output gear lifting screw, gear assembly

directly body removed; unscrew the cover eight bolts, remove the I block I block piston cylinder assembly and assembly; remove the 15 spring and spring pins; I removed the clutch master gear driven friction plate, then remove I block the rest of the ring gear driven and active tablets and tablets; I take out gear and reverse gear planetary carrier ring gear assembly.
　　
2、取出摩擦片隔离架总成；取出倒挡离合器主、从动摩擦片；用2个M10的起吊螺拧入倒挡行星轮架总成的起吊螺孔内以取出倒挡行星轮架总成，然后取出余下的主、从动摩擦片；取出倒挡活塞总成。
Remove the lining of the spacer frame assembly; remove the reverse clutch master, driven friction plates; with two M10 lifting screw screwed into reverse gear in the planetary carrier assembly lifting screw to remove the reverse gear planetary carrier assembly, then remove the remaining owners, driven friction plate; remove reverse gear piston assembly.
　　
3、济南装载机http://www.sdyongbaojixie.com/油封换完后，按拆卸相反的顺序进行装配。
After changing the oil seal loader Jinan, according to the reverse order of disassembly assembly.