装载机调节器如何进行维护?
[ 发布日期:2023-01-07 15:10:28 ] 来源:永保机械 浏览:532次
1、我们必须要保持装载机发电机清洁,当因触点间沾有灰尘或其它原因不能闭合时,发电机电压将随转速升高而升高。要将装载机配件的护板上的小气孔的硬标胶薄体和塑料薄体,以防落入蓄电池内的杂质附在极板上造成短路。
We must keep Shandong loader generator cleaning, when the contact is stained with dirt or other reasons can not be closed, the generator voltage will vary with the speed increased. Hard rubber thin body and a plastic thin body to shield the loader accessories on the small pores, to prevent falling into the impurity in the accumulator of the short circuit caused by the plate.
2、对于装载机配件来进行一个彻底的更换,乳沟是有蓄电池或者是有无蓄电池在进行作业的时侯,那么你们是必须要严格的保持负极搭铁,否则会烧坏二极管。
For Shandong loader accessories to make a thorough change, cleavage is a battery or there is no battery in operation time, then you must be strictly maintained negative ground, otherwise it will burn diode.
3、当你们在检修山东装载机的时候应该要注意,将发电机高速运转时,不要突然卸载,否则也会烧会二极管。
When you loader in the maintenance of Shandong should pay attention to, the generator is running at high speed, not sudden unloading, otherwise it will burn will diode.
4、当遇到装载机的发动机熄火后,应立即将电锁钥匙拔到零位或取下,否则蓄电池将长期放电,从而造成电池亏电,磁场绕组烧坏。
When Shandong met the loader engine flameout, should immediately lock keys to zero or remove the battery,otherwise will be long-term discharge, thus cause the battery power loss, magnetic field winding.