你好!欢迎进入山东永保装载机械官网!  联系电话:139-6410-8518    0531-84917777

新闻资讯当前位置:首页 > 新闻资讯

装载机制动器活塞卡死怎么办?

[ 发布日期:2023-01-07 15:10:28 ]    来源:永保机械    浏览:821次

装载机钳盘式制动器是装载机配件的一种,其防污能力差,活塞常因锈蚀或太脏而卡死。
Shandong loaders caliper disc brake is a loader accessories, and its anti-fouling ability, often due to corroded or dirty piston and stuck.
 
装载机活塞卡死不是很严重时,可以用撬棍橇出,或用锤子敲打制动器背面使其靠惯性振出;卡死过紧时,可在制动器正对活塞中心的背面钻一个8mm的通孔,然后用冲子或螺栓伸入孔中用锤子敲打,就很容易将活塞取出。修复或更换后,再用M10的丝锥在孔内攻丝,然后用M10乘10的螺栓及铜垫片堵住此孔。
Shandong loaders live Fonseca died not very serious, you can ski out with a crowbar, or with a hammer on the back of it by inertia brake vibration out; when stuck tight, in the center of the brake piston is on the back of an 8mm drill through hole, and then inserted into the hole punch or bolt with a hammer, it is easy to remove the piston. Repair or replacement, and then tap in the hole tapping M10, M10 and then multiply by 10 bolts and copper gaskets block this

hole.

Copyright © 2023-2029 山东永保装载机械  版权所有

联系人:周经理    手 机:139-6410-8518     电 话:0531-84917777

地 址:山东济南市商河县怀仁镇工业园

备案号:鲁ICP备14006215号-1    技术支持:亘安信息

扫一扫二维码!