装载机的发动机运转功能分析

1、装载机http://www.sdyongbaojixie.com/的发动机启动后，应立即减小油门，使发动机处于怠速运转状态，检查此时的发动机油压力，确保机油压力不低于98kpa，装载机发动机启动后，不应立即进行全负荷运转，应当使发动机怠速运转5分钟后，然后中速空载运转加热，当冷却液温度达60℃以上时，才允许提高到最高转速，投入满负荷工作。
After the loader engine is started, should immediately reduce the throttle, so the engine is idling state, this time to check the engine oil pressure, oil pressure to ensure that not less than 98kpa, loaders after the engine starts,should immediately conduct a full load operation, should enable the engine to idle for 5 minutes, then heating load running speed when the coolant temperature reaches above 60 ℃, up to the maximum speed allowed, into full capacity.

2、应缓慢增减装载机发动机的转速和符合，特别是对刚启动着的发动机，不允许猛轰油门高速运转。
Should slowly decrease loader engine speed and load, especially just started the engine, Meng throttle does not allow high-speed operation.

3、装载机http://www.sdyongbaojixie.com/发动机运转时，应经常检查机油压力和冷却液温度，在发动机正常工作期间冷却温度一般在85-95℃左右，机油压力应在294kpa-490kpa，任何情况下机油压力不能低于98kpa，否则应及时查明原因并排除故障。
When the engine is running loaders should always check the oil pressure and coolant temperature, engine during normal working cooling temperature is generally around 85-95 ℃, the oil pressure should be at 294kpa-490kpa, oil pressure

under any circumstances can not be less than 98kpa, otherwise should promptly investigate the cause and troubleshooting.