装载机应该加多少传动油？

1.装载机加传动油加到加油孔里面有10CM油就足够了。
1.Shandong loader plus drive oil added to the gas hole inside the 10CM oil is enough.

2.装载机变速油很简单，首先你先用铲车挖个坑，把车在坑上面变速箱对准坑。然后直接拆油底壳下面的那个最大的油管。
2.Shandong loader gear oil is very simple, first you shovel to dig a hole, put the car in the pit above the gearbox alignment hole. Then directly remove the oil pan under the largest tubing.

3.然后把变速箱箱体上有两个的把下面的那个开关打开，一直加到下面的开关开始漏油，那么你在继续加10秒左右就可以了（有的只有一个开关，同样也是加到漏油然后继续加10多秒再关闭)，一般都是一桶半多一点。
3.Then the gearbox has two to open at the bottom of the switch, has been added to the following switch began to leak, then you continue to add about 10 seconds can (some only a switch, is also added to the oil spill and continue to add more than 10 seconds and then close), the general is a bucket of half a point.