济南装载机应该如何正确驾驶？

一、检查车辆 　　

1、检查行车、驻车制动可靠性。
Check the traffic, the parking brake reliability.　　
2、检查空载时铲斗系统运行情况。
Check the operation of the system when the bucket load.　　
3、检查燃油、冷却水及润滑油情况。
Check the fuel, cooling water and lubricating oil situation.
二、起步　　
l、起步前观察四周，确认无妨碍安全行车的障碍后，先鸣笛，再起步。
Look around before the start, after confirming that no obstacles impede safe driving, first whistle, and then started.　
2、制动气压表读数达到规定值方可起步。
Brake pressure gauge reading reaches a predetermined value before starting.　　
3、起步时不得突然加速，应平稳起步。
May not start suddenly accelerated, should smooth start.
三、行驶　　
1、行驶前取下前后车体安全联接杆，并妥善保管。
Remove the front and rear body before driving safety coupling rod, and safekeeping.　　
2、应尽量避免在斜坡横向行驶及铲装物料。　
Should avoid driving and shoveling materials lateral ramp.
3、改变行驶方向及变换驱动操纵杆必须在车停后进行。
Change direction and change the drive lever must be in the car parked.
4、运载物料时，应保持动臂下铰点离地面400mm以上。不得将铲斗提升到最高位置运送物料。
When carrying materials should be kept under the hinge point of the boom more than 400mm from the ground. Bucket may not be elevated to the highest position for delivering materials.　　
5、在坡道上行驶时，应使拖起动操纵杆处于接通位置，拖起动必须是正向行驶。　
When traveling on ramps should make the drag start lever in the ON position, dragging starter must be traveling forward.

济南装载机：http://www.sdyongbaojixie.com/