山东小型装载机如何更换变速油箱油？

1、接油容器放在放油螺栓下，取下螺栓，并放油。为防止小型装载机邮箱内油突然流出，松开螺塞，并逐渐取下螺栓。
Then placed in a container of oil under the oil drain plug, remove the bolts, and put the oil. To prevent a sudden outflow of small loaders mailbox oil, loosen the plug, and gradually remove the bolts.
2、放油后，装在螺塞并拧紧。
After the release of oil, mounted on plug and tighten.
3、接油容器放在小装载机变速箱滤油器下。
Then oil container on a small loader gearbox oil filter.
4、取下小装载机变速箱滤油器放油螺塞，放油后拧紧螺塞。
Remove the small loader gearbox oil filter drain plug, and tighten the oil drain plug.
5、取下螺塞、盖，并取出滤网。
Remove the plug, cover, and remove the filter.
6、清除粘在小装载机滤网上的赃物，然后用柴油或清洗油清洗，如滤网损坏，更换。
Clear filter stuck on a small loader stolen goods, and diesel oil washing or cleaning, such as the filter is damaged, replace it.
7、装配盖上螺栓时，按住盖，均匀紧固螺栓，重新安装滤网。
Cover assembly bolts, hold down the lid, tighten the bolts evenly, reinstall filter.
8、经加油口注入一定数量的机油。
After a certain amount of filler injected into the oil.
9、检查油位，并加油至规定油位，检查滤油器盖装配处是否漏油。
Check the oil level and oil to the specified oil level, check for leaks at the oil filter cap assembly.

山东装载机：http://www.sdyongbaojixie.com/